Remove boot-mode/reset requirements for T3S3 flashing

Boards.h

@@ -42,8 +42,10 @@
   #define MODEL_A7            0xA7 // RNode v2.1, 868 MHz
 
   #define BOARD_RNODE_NG_22   0x42 // RNode hardware revision v2.2
-  #define MODEL_A1            0xA1 // RNode v2.2, 433 MHz
+  #define MODEL_A1            0xA1 // RNode v2.2, 433 MHz with SX1268
-  #define MODEL_A6            0xA6 // RNode v2.2, 868 MHz
+  #define MODEL_A5            0xA1 // RNode v2.2, 433 MHz with SX1278
+  #define MODEL_A6            0xA6 // RNode v2.2, 868 MHz with SX1262
+  #define MODEL_AA            0xA6 // RNode v2.2, 868 MHz with SX1276
 
   #define PRODUCT_TBEAM       0xE0 // T-Beam devices
   #define BOARD_TBEAM         0x33

Makefile

@@ -203,17 +203,11 @@ upload-rnode_ng_21:
 	python ./Release/esptool/esptool.py --chip esp32 --port /dev/ttyACM0 --baud 921600 --before default_reset --after hard_reset write_flash -z --flash_mode dio --flash_freq 80m --flash_size 4MB 0x210000 ./Release/console_image.bin
 
 upload-t3s3:
-	@echo
-	@echo Put board into flashing mode by holding BOOT button while momentarily pressing the RESET button. Hit enter when done.
-	@read
 	arduino-cli upload -p /dev/ttyACM0 --fqbn esp32:esp32:esp32s3
-	@sleep 2
-	python ./Release/esptool/esptool.py --chip esp32s3 --port /dev/ttyACM0 --baud 921600 --before default_reset --after hard_reset write_flash -z --flash_mode dio --flash_freq 80m --flash_size 4MB 0x210000 ./Release/console_image.bin
-	@echo
-	@echo Press the RESET button on the board now, and hit enter
-	@read
 	@sleep 1
 	rnodeconf /dev/ttyACM0 --firmware-hash $$(./partition_hashes ./build/esp32.esp32.esp32s3/RNode_Firmware.ino.bin)
+	@sleep 3
+	python ./Release/esptool/esptool.py --chip esp32s3 --port /dev/ttyACM0 --baud 921600 --before default_reset --after hard_reset write_flash -z --flash_mode dio --flash_freq 80m --flash_size 4MB 0x210000 ./Release/console_image.bin
 
 upload-featheresp32:
 	arduino-cli upload -p /dev/ttyUSB0 --fqbn esp32:esp32:featheresp32