Made HOWTO a tiny bit better.

Documentation/HOWTO-change-firmware-and-compile-it_MeesElectronics.md

@@ -2,7 +2,7 @@
 
 ## Required knowledge
 
-This document assumes some basic knowledge of programming. Like using code editors to edit source code and using basic commands like `make`. Plus some basic Linux knowledge.
+This document assumes some basic knowledge of programming. Like using code editors to edit source code and using basic commands like `make`. Plus some basic Linux knowledge. But you don't have to be an expert.
 
 ## Dependencies
 
@@ -93,7 +93,7 @@ release-waveshare-esp32-s3-pico:
 
 ### Boards.h
 
-The file `Board.h` is the most important file to edit. This is the place where the supported boards are defined. For our new board should, a new section has to be added. This section defines the pinout of the SPI port and if it has certain peripherals such as a screen or BLE.
+The file `Board.h` is the most important file to edit. This is the place where the supported boards are defined. For our new board, a new section has to be added. This section defines the pinout of the SPI port and if it has certain peripherals such as a screen or BLE.
 
 First, the new board has to be defined at the beginning of the file. Search for the line `#define MODEL_FF  0xFF // Homebrew board, max 14dBm output power` and add our definition below that line. Like so:
 

Makefile

@@ -156,7 +156,7 @@ firmware-heltec_t114_gps:
 	arduino-cli compile --log --fqbn Heltec_nRF52:Heltec_nRF52:HT-n5262 -e --build-property "build.partitions=no_ota" --build-property "upload.maximum_size=2097152" --build-property "compiler.cpp.extra_flags=\"-DBOARD_MODEL=0x3C\" \"-DBOARD_VARIANT=0xCB\""
 
 # Added board from Mees Electronics
-firmware-waveshare-esp32-s3-pico: check_bt_buffers
+firmware-waveshare-esp32-s3-pico:
 	#arduino-cli compile --fqbn esp32:esp32:ttgo-lora32 $(COMMON_BUILD_FLAGS) --build-property "compiler.cpp.extra_flags=\"-DBOARD_MODEL=0x61\""
 	arduino-cli compile --fqbn "esp32:esp32:esp32s3:CDCOnBoot=cdc" $(COMMON_BUILD_FLAGS) --build-property "compiler.cpp.extra_flags=\"-DBOARD_MODEL=0x61\""